Aluminum Sliding Glass Door Removal

Posted on: November 14, 2019 by in Uncategorized
No Comments

Aluminum Sliding Glass Door Removal

Just recently I explained how to identify your existing moving glass door so you can purchase the vinyl replacement door. Today I am going to examine the actions required to remove the old sliding door prior to establishing the new door.

The big bulk of doors out there have the moving panel on the within half of the track, and the set panel is on the outside. To eliminate the set panel, you need to eliminate the sill cap that snaps into the bottom track and ranges from the set panel to the side jamb where the moving panel locks. You can raise the panel up as far as it will enter into the leading channel and swing the bottom far from the track, and remove the panel.

Now, you want to eliminate all the screws from the side jambs, leading header, and bottom track. Take a lever and get it under the bottom track about in the. Start with either half and raise the cut piece up towards the side jamb up till the track piece separates from the side jamb.

Now you need to eliminate the side jambs. There will be many nails holding each jamb in area, so you prefer to start at the bottom and work your technique to the leading corner. Various times you can get the jamb with both hands and pull the rest of the nails complimentary as you go up when you get the bottom 3rd loose.

At this minute you are all set to establish the new door. The setup treatment is a little numerous, relying on whether you’re establishing a retrofit style frame or a replacement frame. We will discuss both treatments next week.

To get rid of the set panel, you need to get rid of the sill cap that snaps into the bottom track and runs from the set panel to the side jamb where the moving panel locks. You can raise the panel up as far as it will go into the leading channel and swing the bottom away from the track, and get rid of the panel.

To get rid of the set panel, you need to get rid of the sill cap that snaps into the bottom track and runs from the set panel to the side jamb where the moving panel locks. The big bulk of doors out there have the moving panel on the within half of the track, and the set panel is on the outside. To get rid of the set panel, you need to get rid of the sill cap that snaps into the bottom track and runs from the set panel to the side jamb where the moving panel locks. You can raise the panel up as far as it will go into the leading channel and swing the bottom away from the track, and get rid of the panel.

Comments are closed.